|
|
Overlap by
Specify the method by which the overlap area will be calculated. In this overlap area, areas will be milled both by waterline cutting during regular layer milling, and also between layers by surface pocketing.
|
Angle |
The overlap will be determined by angle. Overlap Angle is the angular offset from the contours that define the boundary of the areas to be milled by waterline cutting. |
|
Length |
The overlap will be determined by length. Overlap Length is the 2D linear offset from the contours that define the boundary of the areas to be milled by waterline cutting. |
Note: The overlap is determined by offsetting the 3D contours that surround the nearly-horizontal area. The 3D contours are offset "inward" by the Overlap value. In other words, the waterline cutting machining will extend into the surface pocketing area by this overlap amount.
|
