Remachine - Legacy Procedures / Spiral Cut

The cutter moves in spiral motions.

Cleanup, Spiral Cut has the following sub-options:

Split Horizontal / Vertical - The horizontal areas are milled on surface, and vertical areas are milled in Constant Z down steps.
All Area on Surf (Parallel and Spiral only) - Both horizontal and vertical areas are milled the same way, on surface.
Only Horizontal on Surf - Only horizontal areas are milled, on surface.
Vertical + All Area on Surf (Parallel and Spiral only) - All surfaces are milled on surface. In addition, the vertical areas are also milled in Constant Z down steps.

Notes:

To mill only vertical areas, using Constant Z down steps, choose the Remachine - Legacy Procedures > Only Vertical Area.
To automate the Cleanup procedure, choose Remachine sub selection Cleanup.

The following list shows an illustration of each Legacy Cleanup option: