Toolpath UCS

The Toolpath UCS (TP UCS) is actually not used in GPP2. It is mentioned here for completeness only.

The only use of the TP UCS is when defining the HOME point. With GPP2, the HOME point is always specified relative to the TP UCS (that takes place in the Cimatron PP interaction). However, the HOME point is immediately translated to the REF coordinate system. For that reason, the TP UCS is not truly relevant inside GPP2.

Note: The TP UCS was also not fully available in old GPP (orientation was not known).

Some functionality may be dependent on the product package. Contact your Reseller if you require a license.