Cuts Information
There is information about the amount of cuts that will be applied to complete the job on the right side of the windows The information is divided in columns as shown below.
| Column | Description |
| Path type | Information about the type of cut |
| Offset | Offset value to apply to the current process, this value is taken from the Database. |
| T(1) | Wire thread |
| C(1) | Wire cut |
| IS(1) | Initial stop |
| FS(1) | Final stop |
| I(1) | Invert path |
(1)
The parameters will be applied if its status is checked
.
The status will depend on the path types that will be applied and also on the remnant parameter.
