|
|
Multi Horizontal Levels Parameters
The Multi Horizontal Levels branch provides for some pre-finish passes before the final finish pass, all in the same procedure, on horizontal regions of the following Finish procedures:
-
Surface Milling > Finish Mill All: where Machining Method = Spiral, Parallel or 3D Step.
-
Surface Milling > Finish by Limit Angle: where Horizontal Areas is checked and Horiz. Machining Method = Spiral, Parallel or 3D Step.
-
Surface Milling > Finish Horiz. Planar Areas: where Horiz. Machining Method = Spiral or Parallel.
The following branch options are available: On and Off -- Off is the default option.
Branch option: On
For a parameter description, click on a parameter in the dialog image below.
Depending on the procedure and your parameter settings, some parameters may not be available or other parameters may be displayed.
|
|
|
Branch option: Off
The default option for this branch is No. This means that there is no multi layer machining.
|
