Approach/Retract Tolerance

Set a separate tolerance for approaches and retracts. This enables you to work with a bigger tolerance for the surface milling and to set a different approach/retract tolerance to avoid gouges.

(This parameter is set in the Tolerance & Surf. Offset branch of the parameter table for the Finish, Pencil and Cleanup procedures.)

Note: This parameter is only displayed in the parameter table if it is enabled in the NC Preferences > General Preferences. If the checkbox for Show Approach/Retract Tolerance is selected, the parameter is displayed.

If this checkbox is not selected, the parameter is not displayed in the NC parameter table.

Some functionality may be dependent on the product package. Contact your Reseller if you require a license.