Picking Part2 Surfaces
Access: Open this function from the following location:
-
Part2 surface selection mode:
Either press the
button in the Work Mode Dialog (if you are in Wizard Mode), or display the Geometry parameters in the parameter tables.
The Geometry Table is displayed:
To start picking the required geometry, press the numbered button adjacent to the Part2 Surfaces geometry parameter. This button displays the number of part2 surfaces that have already been selected. You are then prompted to pick the required geometry.
See Selecting / Unselecting Geometry.
See the cursor symbols in Cimatron when picking geometry.
Part2 surfaces act like part surfaces, but can have different tolerances and offsets.
|
|
|
Once surface selection mode is invokedinvoked, there are several ways to pick surfaces.
Notes:
-
If you want to define a Part2 Surface Offset, open the Offset and Tolerance section of the Parameter Tables.
-
You can narrow your choices of available surfaces by opening the Selection Filter menu.
-
Part surfaces take precedence over part2 surfaces. In other words, if you define a surface as part and later define the same surface as part2, the surface will be considered a part surface.
Additional geometry selection methods are:
