Mark as Work Part

Access: Open this function from one of the following locations:

Select Parting > Layout Tools > Mark as Work Part from the menu bar.
Select Parting Layout Tools > Mark as Work Part from the Mold Design Guide Toolbar or Parting Guide Toolbar.

Mark a part as a work part.

It is required to mark work parts as such for the proper operation of the Parting application.

Notes:

It is recommended to add work parts using the Load Work Parts, but if a part is already there, it can be marked as such using the Mark as Work Part function.
Any part that is added to the parting sub-assembly not through a designated tool is considered by the Parting application as a parting surface part.
Parts that are inside a sub-assembly within the parting sub-assembly, are not considered by the Parting application at all (usually these will be ECO parts).

General Interaction

The following is the Feature Guide for Mark as Work Part.

Tip: You can open the Feature Guide at any time by right-clicking the mouse in the graphic display area.

Required Step 1 : Pick the component(s) to be marked as work part(s).