Machining Between Layers - Const Z

Acts as waterline cutting - material is removed in layers by constant down steps. Material can be removed as volume (sub selection: parallel cut, spiral cut, or stock spiral), or by contour milling.

N ote: The parameters that appear depend on whether the procedure is Volume or Surface Milling.

General Notes about Parameter Tables.

Volume - Parallel Cut

Click on any item in the menu below for an explanation.
(Depending on your choices, some parameters may not be available.)

Volume - Spiral Cut

Click on any item in the menu below for an explanation.
(Depending on your choices, some parameters may not be available.)

Volume - Stock Spiral

Click on any item in the menu below for an explanation.
(Depending on your choices, some parameters may not be available.)

Contour milling

Click on any item in the menu below for an explanation.
(Depending on your choices, some parameters may not be available.)

Some functionality may be dependent on the product package. Contact your Reseller if you require a license.