Tool Trajectory Parameters: Remachine 
> Pencil 
Machine one pass along all internal sharp corners in the part, as well as areas with radius of curvature smaller than the cutter radius. The results of this procedure are clean and smooth internal corners.
Note: If multiple cutters are defined for the procedure (in the Cutters & Holders parameter table), an additional overlap parameter is displayed in the Tool Trajectory table. This parameter defines the type of overlap (if any) between the tool pass of one cutter and that of another cutter. This overlap parameter is Cutters Overlap.
Tool Trajectory parameters
For a parameter description, click on a parameter in the dialog image below.
Depending on your parameter settings, some parameters may not be available or other parameters may be displayed.
|
|
|
