|
|
Customizing Procedure Parameter Tables: Load Look Only 
Access: Open this function from one of the following locations:
The options for loading and saving the default parameter values and also the look (hide/show status):
|
Select NC Edit > Preferred
Look > Load
- Load the default
parameter values and also the default look (hide/show
status). |
|
|
At
the bottom of the Technology
section of an
active procedure, press either the: |
to load the Load the Preferred Look Only of your NC parameter tables. This is your user-defined default as to which parameters are displayed (hide/show status). This does not load their user-defined default parameter values -just which parameters are displayed.
Parameters in the NC procedure tables can be reset to default values. These default values can either be Cimatron supplied or user-defined.
When you load the default values, the system loads the user-defined defaults (if they have been created). If user-defined defaults have not been created, the Cimatron supplied defaults are loaded.
One set of defaults can be saved per procedure technology. These defaults are then loaded into a file with the corresponding technology.
The Cimatron-defined default parameter values are located in the following folder:
\ProgramData\Cimatron\Cimatron\2026.0\Data\It\var\profiles\Cimatron
The user-defined default parameter values are located in the following folder:
\ProgramData\Cimatron\Cimatron\2026.0\Data\It\var\profiles\<user_name>
The following default parameter value options are available:
|
Load Defaults |
Load the default parameter values and also the default look (hide/show status). The geometry and cutter are not changed. |
|
Save |
Save the default parameter values and also the default look (hide/show status). |
|
