Automatic Coloring

Access: Open this function from the following location:

Access: Open this function from one of the following locations:

Select Analysis > Tools > Automatic Coloring from the menu bar.
Select Automatic Coloring from the Electrode Guide Toolbar.
To display these options, activate an electrode.

Assign colors and sets to faces based on their direction, position and function. For example, for electrodes, single-color sets will be created for the burning area, extension and base.

For the electrode designer, the single-color sets validate the electrode design. For the electrode manufacturer, they enable the automatic and clear selection of the appropriate geometry to be used in NC Templates.

Electrode before the Automatic Coloring analysis:	Electrode after the Automatic Coloring analysis:

General Interaction

The following is the Feature Guide for Automatic Coloring.

Tip: You can open the Feature Guide at any time by right-clicking the mouse in the graphic display area.

Required Step 1 : Pick objects (and wires) to undergo analysis.

Required Step 2 : Set the parameters and start the analysis.

Detailed Interaction

See Options and Results.

Some functionality may be dependent on the product package. Contact your Reseller if you require a license.