|
|
Insert Pocket 
Access: Open this function from one of the following locations:
-
Select Mold Design > Insert > Insert Pocket from the menu bar.
-
Select Insert > Insert Pocket from the Mold Design Guide Toolbar.
Insert a cavity in the relevant active part(s) to make room for an insert.
See Insert Tools for an introduction to inserts.
Insert pockets for complex lifters. This function is very similar to the Lifter Pocket function; see Lifter Pocket for explanations.
General Interaction
The following is the Feature Guide for Insert Pocket.
|
|
|
Tip:Required Step 1 
: Pick the lifter for which a pocket is required. The shape of the created pocket is the same shape as the lifter.
Required Step 2 : Pick the target part either from the graphics area or from the Assembly Tree. The target part is the active part to be cut by the lifter selected in the 1st step.
Detailed Interaction
See Options and Results.
|
