|
|
Picking Check Surfaces
-
Check surface selection mode:
Either press the
button
in the Work Mode Dialog
(if you are in Wizard Mode),
or display the Geometry
parameters in the parameter
tables.
The Geometry Table is displayed:
To start picking the required geometry, press the numbered button adjacent to the Check Surfaces geometry parameter. This button displays the number of check surfaces that have already been selected. You are then prompted to pick the required geometry.
See Selecting / Unselecting Geometry.
See the cursor symbols in Cimatron when picking geometry.
Check surfaces are surfaces that define the milling boundaries. Milling takes place up to the defined offset from the check surface.
|
|
|
Once surface selection mode is invokedinvoked, there are several ways to pick surfaces.
Additional geometry selection methods are:
Note: If you want to define a Check Surface Offset, open the Offset and Tolerance section of the Procedure Parameter Table.
|
