|
|
Sweep
: Editing
You can edit:
Note: If your changes results in a geometric impossibility, or cause problems in subsequent functions, you will be warned by the Conflict Solver.
Editing the Sweep feature
Right-click on the relevant feature in the Feature Tree, and from the displayed popup submenu, select Edit Feature or Edit Reference Feature as required (see Editing a Feature).
The appropriate function is invoked with the Feature Guide automatically opened at the relevant step. Proceed through the function's steps to edit the feature/reference feature as required.
Click OKOK
or ApplyApply
in the Feature Guide to complete the function.
Note: When editing a sweep reference feature, you cannot edit edges or points this way.
Editing the parameters only (delta, draft angle)
If you want to modify only the numerical parameter(s), either double-click the Sweep Face name in the Feature Tree or double-click an offset face in the display.
All numerical parameters are displayed. Press exitexit to leave edit mode, or click a value to open the Edit Parameters dialog. In this dialog you can enter another value, or enter an equation involving parametric dependency.
After entering the new parameters, click 
or 
to update the feature, or you can update it later. (If you do not update now, all updates will be done automatically the next time you create or edit any feature or object.) Press exitexit to leave edit mode.
Double-click on a sweep face to display the parameter(s). In this case, a draft angle was defined.
Click a value to open the Edit Parameters dialog. Enter a new value or enter an equation involving parametric dependency.
Click to update.
See also
|
